Grizzly G0960 Owner's Manual page 32

64. Turn blade height handle (see Figure 53)
clockwise until blade is higher than log bunks,
log supports, and log clamps.
Figure 53. Location of blade height handle.
65. Move carriage so blade is above log bunk.
66. Measure distance between back of blade and
top of log bunk near each blade guide (see
Figure 54).
Figure 54. Measuring distance between blade
and log bunk (right side shown).
— If distances between back of blade and log
bunk are equal, no adjustment is neces-
sary. Proceed to Step 68.
— If distances between back of blade and log
bunk are not equal proceed to Step 67.
-30-
Blade Height
Handle
67. Adjust nuts shown in Figure 55 to adjust left
or right side of saw head up or down until
back of blade is same distance from log bunk
on either side.
Saw Head Right Side
Figure 55. Location of saw head leveling bolts
(switch panel removed for clarity).
— Turn nuts clockwise to raise side of saw
mill.
— Turn nuts counterclockwise to lower side
of saw mill.
68. Refer to Calibrating Blade Height Scale on
Page 57 to adjust scale indicator before pro-
ceeding to Test Run.
Model G0960 (Mfd. Since 09/22)
Saw Head Left Side