Grizzly G0960 Owner's Manual page 29

44. Tighten (4) sets of fasteners securing car-
riage leg wheels (see Figure 43).
45. Measure distance between front carriage leg
wheels (see Figure 43).
Note: Measure from just outside of wheel
grooves.
Cable Leg
Wheel
(1 of 4)
Figure 43. Location of carriage leg
wheels (front shown).
— If distance between wheels is 606mm,
no adjustment is necessary. Proceed to
Step 46.
— If distance between wheels is not 606mm,
remove or add
wheels and leg frames to shim wheels
(see Figure 44) until distance is 606mm.
Add or Remove
Washers Here
Figure 44. Location of shimming flat washers.
Model G0960 (Mfd. Since 09/22)
Distance
Between
Wheels
⁄ " flat washers between
3
4
46. Measure distance between rear carriage leg
wheels.
— If distance between wheels is 606mm,
no adjustment is necessary. Proceed to
Step 47.
— If distance between wheels is not 606mm,
remove or add
wheels and leg frames to shim wheels
until distance is 606mm.
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
47. Use forklift or hoist to lift carriage and place it
on track.
Note: Lifting hooks or straps can be secured
to lifting holes in cross beam shown in
Figure 45.
Figure 45. Location of cross beam lifting holes.
⁄ " flat washers between
3
4
HEAVY LIFT!
Cross Beam
Lifting Hole
(1 of 4)
-27-