Grizzly G0960 Owner's Manual page 28

37. Loop end of lift cable B around anchoring hex
bolt, as shown in Figure 39, and secure with
(1) cable clamp.
Lift Cable Anchoring
B
Cable
Clamp
Figure 39. First end of lift cable B secured
(switch panel removed for clarity).
38. Route lift cable B around pulley D, pulley E,
pulley F, and pulley G (see Figure 40), then
loop lift cable around upper right cable plate
hex bolt and secure with (1) cable clamp.
Note: Pulley D and pulley E are lower pulleys
on lift assembly.
G
F
Cable
Clamp
Figure 40. Lift cable B routed around pulleys
(switch panel removed for clarity).
39. Tighten (8) lock nuts securing cable end
plates.
-26-
Hex Bolt
E
D
40. Attach push handle to left rear post with pre-
installed fasteners shown in Figure 41 and
(2) M10-1.5 x 80 hex bolts, (4)
ers, and (2) M10-1.5 hex nuts.
41. Attach scale to saw head with (2) M6-1 x 30
hex bolts and ⁄ " flat washers (see Figure 41).
1
4
Push
Handle
x 2
Figure 41. Push handle and scale installed.
42. Attach scale backing bracket to scale calibra-
tion bracket with (1)
(see Figure 42).
43. Attach scale indicator to scale backing brack-
et, around scale, with (2) M6-1 x 30 hex bolts
and (6) M6-1 hex nuts (see Figure 42).
Scale
Calibration
Bracket
Scale
Indicator
Figure 42. Scale backing bracket and scale
indicator installed.
Model G0960 (Mfd. Since 09/22)
⁄ " flat wash-
3
8
Scale
x 2
⁄ "-18 x ⁄ " knob bolt
5 5
16 8
Scale Backing
Bracket
x 2