Table of Contents
Advertisement
Control Panel
Codepad indicator
icons
Programming Mode
Table 4.1: Icon Indicators
The table below defines the audible indicators given out by the codepad buzzer.
Audible Indicator
One short beep
Two short beeps
Three short beeps
One long beep
One beep every sec
One short beep every min
One beep every 4 sec.
One beep every 2 sec.
Table 4.2: Audible Indicators
4.1.2
Text Codepad Indicators
Codepad Key Functions
Codepad key
Status
Flashing
Definition
A button/key was pressed on the codepad, or Exit Time ended
when armed in STAY Mode 1 or STAY Mode 2.
The system accepted your code.
The requested function was executed.
Indicates the last 10 seconds of Exit Time when armed in AWAY
Mode, or the requested operation was denied or aborted.
Indicates codepad panic/fire/medical alarm operation.
Walk Test Mode is currently active.
There is a system fault waiting to be acknowledged.
During Auto Arming Pre-Alert Time, the warning before
automatic arming takes place.
During Exit Time when armed in AWAY Mode.
Function
Switch the display area on master codepad.
Page up the fault item and recall event.
Turn menu/option item up.
Installation Guide
Accessories | en
Definition
These two indicators flash when you
enter Installer's Programming Mode or
use any Master Code function.
The OFF indicator lights when the
system is disarmed and flashes when a
zone becomes unsealed when
disarmed. The indicator stops flashing
when all zones are sealed.
The ON indicator lights when the
system is armed and flashes when an
alarm occurs. The indicator is reset
after a valid User Code is entered.
2014.07 | 00n | F01U298026
19
Advertisement
Table of Contents
