Operation Parameters - CLIVET WiSAN-YME 1 S 2.1 Manual For Installation, Use And Maintenance

9.19 Operation parameters

The OPERATION PARAMETERS menu is used by the installer or the technician
to check the operation parameters. The values shown on the pages are only indicative.
On the home page, select
MENU > OPERATION PARAMETERS
Press OK
The operation parameters are displayed on the following 9 pages.
Press Down, Up to scroll.
L
NOTE
The energy consumption parameter is calculated, not measured.
If a parameter is not available for the system, the corresponding value will be "--"
The heat pump capacity is indicative and should not be used as a measure of the unit's power.
The accuracy of the sensor is ± 1°C.
The flow-rate parameters are calculated according to the pump operation parameters, the deviation is
different at different flow-rates, the maximum deviation is 15%.
OPERATION PARAMETERS
ONLINE UNITS NUMBER
OPERATION MODE
SV1 STATE
SV2 STATE
SV3 STATE
PUMP_I
OPERATION PARAMETERS
PUMP_0
PUMP_C
PUMP_S
PUMP_D
PIPE BACKUP HEATER
TANK BACKUP HEATER
OPERATION PARAMETERS
GAS BOILER
T1 LEAVING WATER TEMP.
WATER FLOW
HEAT PUMP CAPACITY
POWER CONSUMPTION
Ta ROOM TEMP.
142
1/9
OPERATION PARAMETERS
0
T5 DHW WATER TANK TEMP.
DHW
T 1B CIRCUIT2 WATER TEMP.
OFF
T1S C1 CLIM.CURVE TEMP.
OFF
T IS2 C2 CLIM. CURVE TEMP.
OFF
TW_0 PLATE W-OUTLET TEMP.
OFF
TW_I PLATE W-INLET TEMP.
2/9
OPERATION PARAMETERS
OFF
Tbt1 BUFFERTANK_UP TEMP.
OFF
Tbt2 BUFFERTANK_LOW TEMP.
OFF
Tsolar
OFF
SOFTWARE
OFF
OFF
3/9 OPERATION PARAMETERS
ODU MOD.
OFF
COMP.CURRENT
--°C
0.00M3/H COMP.FREQUENCY
0.00kW COMP. RUN TIME
COMP. TOTAL RUN TIME
0 kWh
--°C EXPANS.VALVE OPENING
OPERATION PARAMETERS
4/9
FAN SPEED
25°C
IDU TARGET FREQU.
--°C
FREQ.LIMITED TYPE
0°C
SUPPLY VOLTAGE
0°C
DC GENERATRIX VOLTAGE
0°C
DC GENERATRIX CURRENT
0°C
OPERATION PARAMETERS
5/9
T W_0 PLATE W-OUTLET TEMP.
0°C
TW_I PLATE W-INLET TEMP.
0°C
T2 PLATE F-OUT TEMP.
0°C
T2B PLATE F-IN TEMP.
IDU 00-00-2000V00
T h COMP. SUCTION TEMP.
Tp COMP. DISCHARGE TEMP.
6/9 OPERATION PARAMETERS
0 kW
T3 COIL F. TEMP.
0 A
T3 OUTDOOR AIR TEMP.
0 Hz TF MODULE TEMP.
0 MIN P1 COMP. PRESS.
0 HOURS
ODU SOFTWARE
0 P HMI SOFTWARE
Control
Installer
7/9
0 R/MIN
0 Hz
0
0V
0V
0A
8/9
0°C
0°C
25°C
--°C
25°C
25°C
9/9
25°C
25°C
0°C
0 kPa
00-00-2000V00
24-02-2021V67