Table of Contents
Advertisement
CPG4000DHY-UK - 3600W WIRELESS REMOTE START OPEN FRAME INVERTER
During operation the muffler and exhaust fumes will become
hot. If adequate cooling and breathing space are not supplied,
or if the generator is blocked or enclosed, temperatures can
become extremely heated and may lead to fire.
Do Not install or operate this generator with any muffler/
exhaust extraction or extension in place otherwise you will
damage the engine. Failure to comply with this results in your
warranty immediately invalidated and terminated.
Surge Protection
Electronic devices, including computers and many programmable
appliances use components that are designed to operate within a
narrow voltage range and may be affected by momentary voltage
fluctuations. While there is no way to prevent voltage fluctuations,
you can take steps to protect sensitive electronic equipment.
– Install CE & UKCA Certified, plug-in surge suppressors on the
outlets feeding your sensitive equipment.
Surge suppressors come in single- or multi-outlet styles.
They're designed to protect against virtually all short-duration
voltage fluctuations.
Wireless Set button
The wireless set button is a feature that lets the user synchronize
the remote key fob to the generator. Up to two remote key fobs
can be synchronized to the generator at a time. Follow the
proceeding steps to reset a remote or synchronize two remotes:
1. Press the START/STOP button once on the front panel of the
generator. The button will flash green once per second.
2. Push and hold the wireless set button for approximately three
(3) seconds. The wireless set button will illuminate blue and
the START/STOP button will stop flashing.
WARNING
WARNING
3. Push and release the STOP $ button on the remote key
fob. The START/STOP button will flash green once and the
wireless set button will flash blue once to indicate the remote
program has been erased.
4. Push and release the START a button on the remote.
The START/STOP button will flash green once and the
wireless set button will flash blue once and again illumniate
blue to indicate the remote has been programmed.
5. Push and hold the wireless set button for approximately three
(3) seconds until the blue light of the wireless set button goes
out, and the green light of the START/STOP button flashes
once per second indicating it is in "STANDBY" mode.
6. Press the START button on the remote to start the engine and
follow the remote STOP instructions to verify the remote(s)
are working properly.
20
OPERATION
Advertisement
Table of Contents
