Wireless Remote Control - Champion CPG4000DHY-UK Operator's Manual

CPG4000DHY-UK - 3600W WIRELESS REMOTE START OPEN FRAME INVERTER

Wireless Remote Control

This generator is equipped with a RED wireless remote control
system for starting and stopping. The system consists of (4) main
components:
1. Receiver Control Module (RCM)
2. Remote Control
3. Start/Stop button
4. Auto-Choke
The Remote Control functions are enabled when:
1. The START/STOP button is in "STANDBY" mode and flashes
green once per second.
The Remote Control functions are disabled when the above
condition is not met.
To start the generator wirelessly, press the "START" a button on
on the Remote Control one time to enter standby mode, indicated
by the START/STOP button on control panel flashing green once
per second. Press the "START" button on the Remote Control
again to start the engine. The engine will attempt to start (6)
times. The RCM controls the Auto-Choke during each attempt
to start. If the generator does not start, call Champion Customer
Care team for assistance at +44(0)1942-715-407.
To stop the generator wirelessly, press the "STOP" $ button on
the Remote Control one time.
Remote Control Power Consumption
While the START/STOP button is in "STANDBY" mode and flashing
green once per second, the RCM is active and waiting for a remote
signal. This standby function requires a small amount of electrical
current from the battery and will shut off automatically after 12
hours.
Pushing and holding the "STOP" $ button on the remote control
for 5 seconds or pushing and holding the START/STOP button
on the control panel for 5 seconds disables the standby function
manually and the RCM will no longer consume any battery power
or wait for remote signal. This is indicated by the START/STOP
button no longer flashing.
14
CONTROLS AND FEATURES