Starting The Engine - Suzuki LT-A400/F 2006 Owner's Manual

Avoid Constant Low Speed
Operating the engine at constant low
speed (light load) can cause parts to
glaze and not seat properly. Allow the
engine to accelerate freely through
the gears, without exceeding the max-
imum recommended throttle opening.
Allow the Engine Oil to Circulate
Before Riding
Allow enough idling time after warm
or cold engine starting before revving
the engine or placing the transmission
in gear. This allows time for the lubri-
cating oil to reach all critical engine
components.
Observe Your Initial and Most
Critical Service
The initial service (break-in mainte-
nance) is the most important service
your vehicle will receive. During
break-in operation, all of the engine
components will have mated together
and seated. Maintenance required as
part of the initial service includes cor-
rection of all adjustments, tightening
of all fasteners and replacement of
dirty oil. Timely performance of this
service will help make sure you get
the best service life and performance
from the engine.
 WARNING
Indicates a potential hazard that
could result in injury or death.

STARTING THE ENGINE

Before attempting to start the engine,
make sure to follow these steps.
1. Set the parking brake.
2. Shift the transmission to neutral.
3. Turn the key to the "ON" position.
4. Set the engine stop switch to the
"RUN" position.
5. Set the fuel valve to the "ON" posi-
tion.
NOTE: The engine can be started in
any gear if you lock the parking brake.
This vehicle has two systems for
engine starting. You can use the elec-
tric starter or the recoil starter. To use
the electric starter, simply push the
electric starter button. When you use
the recoil starter, follow the procedure
below.
• Pull the starter rope slowly until
you feel the starter engage. With
the starter engaged, pull the rope
forcefully to start the engine.
If the idle speed is so low that the
engine rattles just after starting it,
open the throttle briefly to raise the
idle speed.
When the Engine is Cold:
If the ambient temperature is below
5°C (40°F):
1. Move the choke lever to the
ENGAGE position.
2. Push the electric starter button or
use the recoil starter as described
above to start the engine.
3. Immediately
starts, return the choke lever half-
way.
4. When the engine is sufficiently
warmed up, move the choke lever
to the "OFF" position.
3-6
after the engine