Advertisement
Attaching and Setting up the TR3 Rake:
Fig. 1 – Top Link
*NOTE: Ensure the Draw Bar on the Tractor is pushed in before hooking up the TR3 to the Tow Vehicle. Make
sure the bottom 3 point arms are set to the same length, and that the Tractor sway bars are fully locked on the
bottom 3 point arms prior to operation.
ABI
(Absolute Innovations, Inc.)
# 1
Step 1 – Attach the tractor to the lower arms
indicated by arrow #1 in the picture. There are two
connecting holes on the TR3 for the bottom arms of
the tractor to attach to. If the TR3 is connected to
the bottom holes, then make sure to connect the
Top Link in the bottom holes on the mast shown by
#2
the arrow labeled #2. If the lower arms of the
tractor are connected to the TR3 in the top hole,
connect the Top Link using the top hole as well. The
Top Link is shown in Fig. 1.
**Some models of Tractors may vary on top link
location. The top link should sit as level as possible
when the TR3 is operational.
Step 2 – Remove the ½" bent pins from the upright
mast on the back that is locking down the leveling
blade. If these pins are already at the top of the
mast up then skip this step and move on to step 4.
If the pins are in place and cannot be removed
from the uprights, then the TR3 may need to be
lowered to the ground to take the pressure off the
pins. Remove the pins and pin each one in the top
hole on the uprights. Make sure to secure the bent
pin back using the provided lynch pin.
- 855-211-0598 -
www.abiattachments.com
Page 4 of 8
Advertisement
