Advertisement
Step 4 – Connect the hydraulic lines to the Tractor, making sure that the fittings are fully secured before
proceeding. Once the hydraulics are properly connected, cycle the hyraulics until the scarifiers move up and down
freely. Make sure to check the hydraulic fluid levels after cylcling the scarifiers to ensure the oil levels have not
been depleted.
*Note for Step 5 – Due to 3 point hook ups on some models of tractors, it may be necessary to move the
tires on the TR3 forward or back a hole to properly adjust the TR3. If you are not able to adjust the TR3 so that the
Leveling Blade and Finish Rake touch at the same time try moving the wheel one hole at a time and then repeat
Step 6. For further assistance on setup of the TR3 contact our Customer Service Department at 855-211-0598.
ABI
(Absolute Innovations, Inc.)
Step 3 – Make sure the Stabilizing wheels are
mounted in the middle hole on the tire mounting
bracket. This can be adjusted later if needed. For
now make sure the tire is mounted in the center
hole.
Step 5 – With the TR3 and Tractor on a hard flat
surface, and the Scarifiers lifted out of play,
adjust the TR3 using the Top Link (shown on page
4 Step 1 Fig 1 above) so that the Leveling Blade
and the Finish Rake touch at the same time. Once
the Leveling Blade and Finish Rake touch at the
same time; lift the TR3 and set it back down. This
will ensure that everything is properly adjusted. If
Leveling Blade and Finish Rake are not touching
at the same time continue to adjust the TR3 using
the Top Link until they touch after the TR3 has
been lifted and lowered. The TR3 may need to be
adjusted multiple times for it to be level. Make
sure to raise and lower the TR3 after every
adjustment.
- 855-211-0598 -
www.abiattachments.com
Page 5 of 8
Advertisement
