Supermicro SSG-5049P-E1CR45L Information page 6

3. Processor
Type and number of fastenings:
Four (4) T30 Torx screws.
Tools required:
Screwdriver with T30 Torx bit.
Procedure:
Remove the screws in the sequence of 4, then 3, then 2, then 1, as marked in the
illustration below. After removing the screws, lift the processor heatsink module off the processor
socket. Unsnap corners A and B, then C and D of the latch. Push the latch out from the bottom.