Grounding Cable And Lug Specifications For Ex9200 Switches - Juniper EX9208 Hardware Manual

Table 50: EX9200 Switch Component Power Requirements
Component
EX9200-40T-MIC
EX9200-12QS line card
EX9200-15C line card
EX9200-32XS line card
EX9200-40T line card
EX9200-40F line card
EX9200-40F-M line card
EX9200-40XS line card

Grounding Cable and Lug Specifications for EX9200 Switches

IN THIS SECTION
Grounding Points Specifications for an EX9200 Switch | 134
Grounding Cable Lug Specifications for an EX9200 Switch | 134
Grounding Cable Specifications for an EX9200 Switch | 135
To ensure proper operation and to meet safety and electromagnetic interference (EMI) requirements,
you must connect an EX9200 switch to earth ground before you connect power to the switch. You must
use the protective earthing terminal on the switch chassis to connect the switch to earth ground.
(Continued)
Typical Power (watt)
41 W
465 W
EX9200-15C Line Card
See
550 W
206 W
219 W
219 W
465 W
Reserved Power (watt)
41 W
545 W
610 W
239 W
239 W
239 W
545 W
133