Mercedes-Benz Metris Operating Instructions Manual page 82

Electric sliding door
80
two warning signals during the opening pro-
cedure.
The indicator lamp in the Å or Æ slid-
ing door button in the center console
flashes for the duration of automatic opera-
tion.
The indicator lamp in the Å or Æ slid-
ing door button in the center console is lit
whenever the respective sliding door is
open. Depending on the vehicle equipment,
the display can also show the
Door Open
message.
X
To close: briefly press the respective Å
or Æ sliding door button in the center
console.
or
X
Briefly press sliding door button A in the
door frame.
or
X
Briefly press rocker switch = forward.
The sliding door is released from its lock
and automatic operation is started. The slid-
ing door closes.
If you use the Å or Æ sliding door
button in the center console you will hear
two warning signals during the closing pro-
cedure.
The indicator lamp in the respective Å or
Æ sliding door button in the center con-
sole goes out whenever the sliding door is
closed.
X
To interrupt automatic operation: press
the respective Å or Æ sliding door
button in the center console again.
or
X
Press sliding door button in the door frame
A.
or
X
Briefly pull back rocker switch =.
i In unfavorable operating conditions, e.g.
frost, ice or heavy soiling, you can press and
hold the relevant sliding door button. The
electric sliding door moves with increased
force. Observe that, in such circumstances,
the obstacle detection is less sensitive. To
stop the movement, release the sliding door
button.
Programing the key button for the
sliding door
If the vehicle is equipped with two electric slid-
ing doors, the 5 sliding door button on the
key can only be program for one of the two
sliding doors. You can then open or close the
selected sliding door with the 5 button on
the key.
Sliding
Sliding door button for sliding door on the
:
left-hand side
Sliding door button for sliding door on the
;
right-hand side
X
Make sure that the sliding door to be pro-
grammed is open.
X
Turn the key to position 2 in the ignition
lock.
X
Press and hold the Å or Æ sliding
door button in the center console for the
appropriate sliding door until the sliding
door is closed and four tones have sounded.
The display shows the
tric Sliding Door Key
Right-hand Electric Sliding Door
Key Programmed
grammed/R. Slide Door Programmed
message.
Resetting the sliding door
You must reset the sliding door if there has
been a malfunction or an interruption in the
voltage supply.
X
If the sliding door is open: close it by hand.
X
Using the Å or Æ sliding door button
on the center console, open the sliding door
at least 15.8 in (40 cm) and then close the
sliding door completely.
Left-hand Elec‐
Programmed/
L. Slide Door Pro‐
or