Mercedes-Benz Metris Operating Instructions Manual page 182

On-board computer (vehicles without steering wheel buttons)
180
Further information can be found under "ESP
(Electronic Stability Program)" (
The vehicle must be stationary and the engine
must be running. Use the buttons in the instru-
ment cluster.
X
Press È to select the
X
Press 3 to select the
The display shows the current status.
If the display shows the
Poss. With Engine On
the message with 3 and start the engine.
The display then shows the
®
and the ESP status.
If the ESP Inoperative
in the display, ESP is not available due to a
malfunction and is deactivated. If you con-
firm the message with 3, the display shows
the next submenu.
X
Press f or g to activate or deactivate
ESP.
X
Press 3 to confirm.
The next submenu is shown in the display.
If the å warning lamp in the instrument
cluster lights up when the vehicle is ready to
®
drive, ESP is deactivated.
Observe the information on warning lamps
Y
( page 230) and display messages
Y
( page 200).
Setting the sensitivity of the rain sen-
sor
The vehicle must be stationary. Use the but-
tons in the instrument cluster.
X
Press È to select the
X
Press 3 to select the
menu.
The display shows the current sensitivity
setting.
X
Press f or g to select the Low,
Sensitive
or setting. This setting controls
the rain sensor's sensitivity to precipitation.
The windshield wiper will then wipe more or
less frequently at the same precipitation
intensity.
X
Press 3 to confirm.
The next submenu is shown in the display.
You can find further information under "Wind-
Y
shield wiper" ( page 109).
Activating/deactivating ATTENTION
®
Y
page 69). ASSIST
The vehicle must be stationary. Use the but-
tons in the instrument cluster.
X
Settings
menu.
X
ESP submenu.
Oper. Only
message, confirm
ESP
submenu
message is shown
X
X
Further information can be found under
"ATTENTION ASSIST" (
Selecting the permanent display func-
tion
With the
can switch the display in the header between
outside temperature and speed.
If the display shows the speed in the header,
the outside temperature is shown with the
odometers (
The additional speedometer unit in the header
is always inverse to the speedometer unit.
The vehicle must be stationary. Use the but-
tons in the instrument cluster.
Settings
menu.
X
Rain Sensor
sub-
X
Standard
X
X
Selecting the unit for the distance
In the
select whether the display shows certain infor-
mation in kilometers or miles.
Press È to select the Settings
Attention Assist
Press 3 to select the
submenu.
The display shows the current status.
Attention Assist Inoperative
If the
message is shown in the display, ATTEN-
TION ASSIST is not available due to a mal-
function and is deactivated. If you confirm
the message with 3, the display shows the
next submenu.
Press f or g to activate or deactivate
ATTENTION ASSIST.
Press 3 to confirm.
The next submenu is shown in the display.
Y
page 155).
Permanent Display:
Y
page 177).
Settings
Using È select the
Permanent Display:
Using 3 select the
submenu.
The display indicates the selected setting of
Outside Temp. or Speedometer.
Change the setting by pressing f or g.
Press 3 to confirm.
The next submenu is shown in the display.
Distance Unit:
submenu, you can
menu.
function, you
menu.