Program Module Size On Program Card; Table 6-15. Program Module Memory Area On Program Card - ABB Advant Controller 450 Product Manual

Object type
Basic requirements for QC07-FUZ41
Basic requirements for QC07-COM41
Basic requirements for QC07-BAS41
(8)
Spare RAM area
Approximative total RAM requirement in kbytes
(1) The figures are calculated for 8 steps (MOTCON not included).
(2) The figures are calculated for 1 table with 10 rows and 100 values per row.
(3) The figures are calculated for 40 text strings with 20 characters and 30 dynamic values.
(4) The figures apply to 100 events per list.
(5) The figures are calculated for 1 log with 10 variables, each with 240 stored values. Each value takes approximately 5 byte.
(6) The figures are calculated for 50 storage vessels, 4 sections and 20 operations with 6 recipe variables each.
(7) This is a recommended starting value. Adjustment of this figure might be necessary to do when the real need is known.
(8) Recommended value for most systems.
(9) Must be less than the RAM size of the processor module (8 or 16 Mbyte).

6.11 Program Module Size on Program Card

3BSE 015 953R201 Rev B
Table 6-14. Calculation of RAM requirement (Continued)
Remark
When stored on the program card, the program modules occupy the following memory areas.

Table 6-15. Program module memory area on program card

Program module
QC07-BOB41
QC07-BAS41
QC07-LIB41
QC07-LIB42
QC07-OPF41
QC07-LOS41
QC07-BAT41
QC07-UDP41
QC07-COM41
QC07-FUZ41
Section 6.11 Program Module Size on Program Card
Total
1
1
1
1
(9)
Advant Controller 450 Product Guide
Factor
RAM req.
(kbytes)
x 40
x 33
x 2207
x 40
Memory area (kbyte)
9
1410
32
405
550
205
279
85
20
40
40
6-15