Connect The Power Cord - NETGEAR ND508 Installation Manual

Connect the Power Cord

To connect the power cord to the Model ND508/ND520 Network Disk Drive:
1. Connect one end of the power cord to the power receptacle on the rear
panel of the Model ND508/ND520 Network Disk Drive, as shown below.
2. Connect the other end of the power cord to a standard power outlet.
Caution: Use the appropriate power cord as required by your national
electrical codes and ordinances.
3. Power on the network disk drive by pressing the power button on the
rear panel.
4. Verify that the LEDs on the front panel display the following:
• The Power LED is green, indicating that power to the network disk
drive is on.
• The Link and Ready LEDs are green, indicating that the network disk
drive is connected to the network and ready for use.
5. Verify that the Link LED is on. If this LED is not on, depress the
Normal/Uplink button on the front panel of the drive.
Model ND508/ND520 Network Disk Drive Installation Guide
Rear Panel of the Model ND508/ND520
Network Disk Drive
Fan Power
button
Power receptacle
9282FA