Troubleshooting; Installation - NETGEAR ND508 Installation Manual

Changing a Private Folder to a Public Folder
To change a private folder to a public folder:
1. From the Main Menu, select Make/Change Private Folders.
2. Click on the private folder you want to change to a public folder.
3. Click on Make Folder Public.
4. Click on OK.

Troubleshooting

This section provides suggestions for troubleshooting the network disk drive.

Installation

To troubleshoot the installation:
1. Verify that all network components have been properly installed.
2. Be sure all cable connectors are securely positioned in the proper ports.
3. Be sure all devices are still connected to the network.
Equipment may have been accidentally disconnected.
LEDs
If the Power LED is not lit:
1. Check the power connections to make sure the ends are securely
plugged into the network disk drive and into the wall outlet.
2. Be sure you are using the appropriate power cord as required by your
national electrical codes and ordinances.
3. Be sure that your power outlet is functioning properly.
If the Link LED is not lit:
1. Press the Normal/Uplink button on the front panel of the network disk
drive.
2. Make sure your Ethernet cable is plugged into an active hub port.
Network Interface Card
Make sure that you have a network interface card (NIC) installed in your PC.
Make sure the card is in working condition.
Configuration/Connections
If a problem occurs after you have altered your network connections:
1. Restore the original connections.
2. Repeat your changes one at a time, to determine which change is
causing problems.
Model ND508/ND520 Network Disk Drive Installation Guide