Electrical Configuration - Oki LP-1040 Installation Manual

2.4

Electrical configuration

The electrical configuration to connect the Printer's power cord is shown below.
(1) Power specifications
The power specifications of the printer are shown below. Confirm that the primary-side power
also satisfy these specifications.
Power voltage:
Power frequency:
Power consumption:
Instantaneous interruption: 10 ms or less
Earth:
Power plug:
Power cable length:
Cautions
The earth is grounded exclusively for the signal wiring to prevent noise due to induction, etc., so do
not connect it with the one for power.
120V AC ± 10% (for USA use)
230V AC ± 10% (for European use), single phase
50/60 Hz ± 1Hz
1450 W or less
Grounding (with the ground resistance of 100 Ω or less)
NEMA 5-15P UL817, CSA C22.2 (for USA use)
CEE7/VII DIN VDE 0620-1, EN50075, IEC 60884-1
(For European use)
3 m (118.11 inches)
2-5
OKI Data Infotech Corporation CONFIDENTIAL
Chapter 2 Site preparation check