System Configuration Menu - Oki C3000 Series Manual

ITEM SETTINGS
CMY 100% DISABLE
DENSITY ENABLE
CMYK ON
CONVERSION
OFF
S
YSTEM CONFIGURATION MENU
This menu adjusts general printer settings to suit the way you prefer to work.
ITEMS SETTINGS
POWER SAVE 5 MIN
TIME 15 MIN
30 MIN
60 MIN
240 MIN
PERSONALITY AUTO
PCL
IBM PPR III XL
EPSON FX
PS3
EMULATION
USB PS RAW
PROTOCOL ASCII
NET PS RAW
PROTOCOL ASCII
CLRABLE ONLINE
WARNING JOB
AUTO ON
CONTINUE OFF
MANUAL OFF
TIMEOUT 30~60~300
WAIT 5~40~300,
TIMEOUT OFF
LOW TONER CONTINUE
STOP
JAM ON
RECOVERY OFF
ERROR ON
REPORT OFF
EXPLANATION
When enabled, black areas are produced using 100% C, M, and Y instead
of black. This results in a glossier finish.
Setting to "OFF" will simplify the conversion process of CMYK data, which
will reduce the processing time.
This setting is ignored when Ink Simulation function is used.
Note: This function only applies to PS models
EXPLANATION
Adjusts the idling time before the printer automatically switches into
power saving mode. In this mode power consumption is reduced to a low
level required to just keep the printer operating and ready to receive data.
When a job is sent the printer will require a warm-up time of up to 1
minute before printing can begin.
This item selects which industry standard emulation your printer should
use. When set to AUTO, incoming data is examined and the correct
emulation is automatically selected each time a print job is received.
Selects PostScript data format for USB port.
Selects PostScript data format for network port.
When ONLINE, non-critical warnings, such as requests for a different
paper size occur, they can be cleared by pressing the ON LINE button.
When set to JOB, they are cleared when the print job resumes.
Determines whether or not the printer will automatically recover from a
memory overflow condition.
Specifies how many seconds the printer will wait for paper to be fed
before cancelling the job.
Specifies how many seconds the printer will wait when received data
pauses before forcing a page eject. In PostScript Emulation mode the job
will be cancelled if timeout occurs.
Specifies whether the printer should continue printing even after a low
toner condition is detected.
Specifies whether the printer should perform jam recovery after a paper
jam has occurred. If ON, the printer will attempt to re-print any pages lost
due to a paper jam once the jam has been cleared.
If ON, the printer will print error details when a PostScript Emulation error
occurs.
Note: Applies to PS & PCL XL only.
Menu functions > 25