Table of Contents
Advertisement
4.3.2 RS232 Settings
1. Connect RS232 device to RS232 port on interface 2. If you need IOT-C501 to power the RS232
device, connect the power cable of RS232 device to power output on interface 2.
2. Go to "General ->Serial" of ToolBox software or "Setting ->Serial Setting" to enable RS232
and configure serial port settings. Serial port settings should the
devices.
Parameters
Interface 2(Pin 1)
Enable 5V/9V/12V power output of interface 2 to supply power to RS232
5V/9V/12V Output
terminal devices continuously.Only UC501 supports this feature.
same
Description
as RS232 terminal
16
Advertisement
Table of Contents
