Introduction
The Prosense hand terminal is designed to help maintenance and calibration operations on
Prosense PQ, PX, P, PC3 series detectors. The hand terminal uses MODBUS communication to
connect the detectors. Prosense PQ, PX, P, PC3 series detectors have onboard MODBUS
communication circuits. User should connect hand terminal MODBUS A and B ports to
detector MODBUS and B ports. Communication ports must match to each other for
communcation. Hand terminal operates with battery power and should be off to manage
Hand Terminal Menu
battery life.
Hand terminal has 3 buttons on display that will be used to perform operation which are
Enter, up (Increase) and down (decrease). To reach configuration menu press Enter. The
screen will request password information:
The password is 1234. User need to change the password as defined in "Change password"
step. You need to set values via using up and down keys. Once the value is set press Enter
again to confirm and move to the next digit. Confirmed digits will be made invisible by
detector program:
The screen will display menu options when correct password entered at last digit:
PRS-UM-HT-EN-Rev1.0-19.12.2022
PASSWORD
0
PASSWORD
****
1. Alarm Settings
2. Calibrate
3. Configure
4. Information
5. Test
6. Exit
4