Run Inhibit Test; Run Display Test; Run Relay Test - Prosense PQ Series User Manual

To perform tests select Test menu item via up and down keys then press Enter key. The screen
will display test options:
To execute tests select desired test option and press Enter key. To return back to previous

Run Inhibit test

menu please select Previous Menu option and press Enter key.
User can initiate detector to work in inhibited mode. In this mode detector will provide the
signal level defined in configuration details for inhibited mode (default is 3mA) and the alarms
will be deactivated. When Inhibit option selected in Test menu below screen will display to set
inhibit detector:
If user finish the work or test it is necessary to clear inhibit mode to return detector to normal
operation. To do this user should re-enter to Inhibit menu in Test menu. The clear option will
be displayed at this time:

Run Display test

To execute display tests select Display option on Test menu and press Enter key. The detector
program will start display test via drawing different patterns. It might take one minute to
complete test. The display will return back to Test menu when test completed.

Run Relay test

It is possible to check relay functions via using menu options. Relays are only available if
optional relay module installed on to detector main board. To run relay test please select test
menu and select Relay option. Screen will display three options to test as there are three
relays on relay module. Select the menu option related to desired relay test and press Enter
key.
PRS-UM-HT-EN-Rev1.0-19.12.2022
1. Inhibit
2. Display
3. Relay
4. Analog Output
5. Bump Test
6. Previous Menu
1. Set
2. Previous Menu
1. Clear
2. Previous Menu
14