Bump Test; Change Test Interval - Prosense PQ Series User Manual

Password must be 4 digits and should be set digit by digit via using up and down keys. When
completed, press Enter key long enough to confirm. The display will show "Successful"
message and return back to higher level menu. User should remember the password to
perform changes later on. If user forgets the password, detector should be returned back to
Prosense to reset password. No Field operation is available to reset password at customer

Bump Test

site.
Detectors should be tested to make sure they can perform their operations as defined. To do
this bump test should be performed in defined periods. Bump test parameters can be
adjusted via using Bump Test options in Configure menu. To start adjustments select Bump
Test step on Display menu. A new screen will display with available options:

Change Test Interval

To change bump test interval select Test Interval option on Bump Test Menu.
Once the bump test interval menu shown the time value will start blinking. User can change
the value via using up and down keys. Select Enter key to save the value when adjustment
done. The display will show "Successful" message and return back to previous menu.
PRS-UM-HT-EN-Rev1.0-19.12.2022
New Password
1. Test Interval
2. Inhibit Warning
3. Previous Menu
Bump Test Interval
3 Month
0
10