Display Data - Raymarine LIGHTHOUSE 4 Operation Instructions Manual

4. The new data item is displayed.
Alternatively, to use physical buttons instead of the touchscreen you can
select [Customize page] from the app menu: [Menu > Customize page] and
then follow the steps above.

Display data

Data transmitted by compatible devices that are connected to the same
network as the display and data generated by the display can be shown as
data items in the Dashboard app, the sidebar and as a data overlay.
Data items are organized into categories.
Note:
• Standard NMEA 2000 PGNs are listed next to the relevant data items.
• Supported Raymarine and 3rd party proprietary messages are not listed.
• NMEA 0183 sentences are not shown.
To view a list of all supported NMEA 2000 PGNs refer to:
p.421 — NMEA 2000 PGN support
To view a list of all supported NMEA 0183 sentences refer to:
NMEA 0183 sentence support
To change or add a data item in the Dashboard app or sidebar select and
hold on the data cell and select [Edit] from the pop-over options to display
the list of data categories.
To change or add data item to a data overlay use the [Page settings] menu
from the relevant MFD app. For details refer to:
Battery data
Batteries are detected automatically by the display.
The following data items are available in the [Battery] category:
• Battery voltage (PGN 127508)
• Battery current (PGN 127508)
• Time till zero charge (PGN 127506)
• Battery temperature (PGN 127508)
• State of charge (PGN 127506)
The data items will be available for each detected battery.
Dashboard app
p.34 — Data overlays
Detected batteries are shown in the battery configuration page: [Homescreen
> Settings > Boat details > Num of batteries > Configure batteries].
Boat data
Boat data requires supported sensors to be connected.
The following data items are available in the [Boat] category:
• (1) Roll (PGN 127257)
• Mast rotation
• Pitch (PGN 127257)
• Rate of turn (PGN 127251)
• Trim tabs (1) (PGN 130576)
Note:
(1) Roll data can only be displayed in the Dashboard app.
Depth data
Depth data requires a compatible instruments or sonar transducer connected
to the display.
The following data items are available in the [Depth] category:
• Maximum depth
• Minimum depth
• Depth (PGN 128267)
Display data
The display data category is used for voltage detected by the display.
The following data items are available in the [Display] category:
• Supply voltage
• Supply voltage level
(1)
Note:
• The display category and data items are not available in the Dashboard
app.
• (1) Data item is only available in the sidebar.
293