Related Manuals for Raymarine M1500
Summary of Contents for Raymarine M1500
- Page 1 M1500 Marine Monitor Owner’s Handbook Document number: 81208_1 Date: June 2003...
- Page 2 Raymarine is a registered trademark of Raymarine Limited.
-
Page 3: M1500 Marine Monitor Preface
Safety notices WARNING:Product installation This equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in poor product performance, personal injury and/or damage to your boat. WARNING: Electrical safety Make sure you have switched off the power supply before you start installing this product. -
Page 4: Emc Conformance
Warranty To register your new Raymarine product, please take a few minutes to fill out the warranty card. It is important that you complete the owner information and return the card to the factory to receive full warranty benefits. -
Page 5: How To Contact Raymarine (Us)
Technical Service is available Monday through Friday 8:15 am to 5:00 pm Eastern Standard Time or Eastern Daylight Savings Time. Please have the Raymarine item or part number ready when calling if placing an order. If you are not sure which item is appropriate for your unit, you should first contact the Technical Support Department at: 1-800-539-5539 ext. - Page 6 M1500 Marine Monitor...
-
Page 7: Table Of Contents
Contents M1500 Marine Monitor Preface ..i Important information ...i Intended Use ..i Safety notices ..i TFT Color LCD Displays ..ii EMC conformance ..ii Handbook information ..ii Warranty ..ii Technical Support: ..ii How to Contact Raymarine (US) ..iii How to Contact Raymarine (Europe) ... - Page 8 Common Problems and Their Solutions ..17 Specification ..18 Accessories ..18...
-
Page 9: M1500 Marine Monitor
Input Composite video/audio - when used with the audio/video junction box accessory (E85003) Note: If your PC has a DVI output Raymarine recommend that for best picture quality the DVI output is used. Recommendations for your PC The M1500 Marine Monitor complies with VESA DDC1/2B Windows Plug and Play. -
Page 10: Features
Features CAUTION: To prevent the ships battery being discharged if the system is left on, Raymarine do not recommend the use of screen savers with navigation displays. Do not use the power save feature of your PC. Power Saving This monitor powers off completely if no video signal is received for more than 30 seconds, for example, if your PC (or other video source) goes into power save or standby mode. -
Page 11: Front Of Monitor
Front of Monitor Stereo speakers For audio output from your PC or audio/video source. Alternatively, a separate sound system may be connected directly to your source device. Display screen High brightness, daylight viewable colour LCD display with high contrast text and graphics. Refer to specifications for resolution details. -
Page 12: Rear Of Monitor
Rear of Monitor Power in Power input connection from the ship's supply (nominal 12V or 24V system). DVI input Digital Video Input from a Personal Computer (PC). VGA input Analogue Video Input from a Personal Computer (PC). Audio input, composite video or S-video input Audio input direct from the PC. -
Page 13: Operation
Operation Power ON/OFF Power ON Power OFF Press and hold Press for 3 secs for 3 seconds Setting the Brightness, Volume and Input Source Selecting What you see the mode Brightness Press Volume Press Video source Analogue (RGB) Composite-S Press Advanced Display Settings To access Set Up menu... - Page 14 RGB Adjust Black Level Adjust Restore Defaults Auto Set Up Language Option list About M1500 Purpose Adjust the display contrast (this has no effect in composite video or s-video mode). Select cool, neutral or warm color temperature. Select the aspect ratio; this is useful if you choose a resolution that has a different aspect ratio to the display (4 x3 at its stan- dard resolution of 1024x 768).
-
Page 15: Installation
Power cable R89005 5 metre PC Audio cable assembly R89006 5 metre VGA cable assembly R89007 15 inch Monitor Suncover R89008 M1500 Marine Monitor Owner Handbook Handbook 81208 M4 nut (x2) Bracket (x2) M8 spacer (x2) M8 side bracket (x2) -
Page 16: Planning
The power connection to the display should be made at either the output of the battery isolator switch, or at a DC power distribution panel. Raymarine recommends that power is fed directly to the display via its own dedicated cable system and MUST be protected by a thermal circuit breaker or fuse, fitted close to the power connection. -
Page 17: Cable Runs
Alternatively, a bracket mount option (E05011) is available. The following section provides the display dimensions and console mounting instructions. Raymarine recommend that you power the unit and select a suitable mounting location prior to installing the display. When planning the display location, the... -
Page 18: Emc Installation Guidelines
EMC Installation Guidelines All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. Their design and manufacture conforms to the appropriate Electromagnetic Compatibility (EMC) standards, but correct installation is required to ensure that performance is not compromised. -
Page 19: Console Mounting - Display Dimensions
Always use the ferrites supplied by Raymarine. Connections to Other Equipment If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near to the Raymarine unit. -
Page 20: Console Mounting - Preparation
Console Mounting - Preparation Cut aperture in surface To ensure correct dimensions, use the template provided. 1 5 " t e m p l a D r il 4 .1 o u n t in g ( 4 p d ia h o le o s it io n... -
Page 21: Console Mounting
Console Mounting To mount the console: 1. Remove the backing paper from the installation gasket. 2. Attach the installation gasket to the back of the display plate. 3. Place display into the aperture, push 4 x M4 screws through holes. 4. -
Page 22: Connections - Typical Installations
Connections - Typical Installations Input Audio, composite video or S-video input using Optional Audio/Video Junction Box DVI Input VGA Input Audio OR . . . Connections to junction box via Scart phono and/or S-video. Details provided with junction box..Audio, Power IN composite from ship's... -
Page 23: Connections - Accessing The Connector Panel
Connections - Accessing the Connector Panel Cable seal Cable clamp kit Push latch to release and close cover Rotate clockwise to secure seal and cover D6367-1... -
Page 24: Maintenance And Problem Solving
Raymarine equipment should be serviced only by authorized Raymarine service tech- nicians. They will ensure that service procedures and replacement parts used will not affect performance. There are no user serviceable parts in any Raymarine product. • Some products generate high voltages, so never handle the cables/connectors when power is being supplied to the equipment. -
Page 25: Problem Solving
Problem Solving All Raymarine products are, prior to packing and shipping, subjected to comprehensive test and quality assurance programs. However, if this unit should develop a fault, please refer to the following table to identify the most likely cause and the corrective action required to restore normal operation. - Page 26 Specification Approvals: CE - conform to FCC - conforms to Size: Weight Mounting Power Fuses Environmental: Operating Temp. Range Non-operating Temp. Range Humidity limit Controls Display Type Resolutions and Refresh Rates Display Size Connectors Accessories Audio/video Junction Box Black Dress Panel Kit Trunnion Mount Bracket Kit E05011 1999/5/EC, EN60945:1997 Part 80 (47CFR) and Part 2 (47CFR)
-
Page 27: Limited Warranty
In cases where a Raymarine certified installer has not installed the product; i.e. Limited Warranty, the affected unit must be returned to the local Raymarine approved service agent, with a copy of proof of purchase and/or completed warranty card. Subject to the Limitations below, the unit will be repaired/replaced at no fur- ther cost to the user and promptly returned to the user. - Page 28 Travel cost allowance on certain products with a suggested retail price below $2500.00 is not authorized. When/or if repairs are necessary, these products must be forwarded to a Raymarine facility or an authorized dealer at owner’s expense and then will be returned via surface carrier at no cost to the owner.
- Page 29 Factory Service Centers United States of America Raymarine Inc. 22 Cotton Road, Unit D Nashua, NH 03063-4219, USA Telephone: +1 603 881 5200 Fax: +1 603 864 4756 www.raymarine.com Sales & Order Services Telephone: +1 800 539 5539 Ext. 2333 or 1 603 881 5200 Ext.