Accessing The Embedded Web Server - 3Com VCX V6000 Manual

16 C 4: C
HAPTER ONFIGURING THE
Accessing the
Embedded Web
Server
V6000/V6100
Address fields under IP Configuration to correspond with your network
IP settings.
Record and retain the IP address and subnet mask you assign the
V6000/V6100. Do the same when defining a new username or password.
5 Click Reset Device, and then at the prompt, click OK; the V6000/V6100
applies the changes and restarts.
6 Disconnect your PC from the V6000/V6100 or from the hub / switch
(depending on the connection method you used).
7 Reconnect the V6000/V6100 and your PC (if required) to the network.
8 Restore your PC's IP address and subnet mask to their original settings. If
necessary, restart your PC and re-access the V6000/V6100 via the
Embedded Web Server with its new assigned IP address.
Table 2 V6000/V6100 Default Networking Parameters
Parameter
IP Address
Subnet Mask
Default Gateway IP Address
To access the Embedded Web Server, perform these steps:
1 Open a standard Web-browsing application such as Microsoft
Explorer ™ (Version 6.0 and higher) or Netscape
and higher).
2 In the URL field, specify the IP address of the gateway (for example,
http://10.1.10.10); the Embedded Web Server's Enter Network
Password screen appears, shown in
Default Value
10.1.10.10
255.255.0.0
0.0.0.0
™ Navigator
Figure 4.
™ Internet
™ (Version 7.2