Special Precautions; Water Connection; Water Draining System - Electrolux 6 GN 1/1 Installation And Operating Manual

Gas heated convection ovens

Hide thumbs

Table Of Contents

Table of Contents

2. Lift the appliance with a lift truck, remove the base;

20 GN

5 1 " 130 mm

6-10 GN

3. Position it the place of use;

4. Remove the protective film;

Make sure the packing material is not dispersed in the

environment but disposed of according to the current regu-

lations in the country where the product is used.

G.1.1

For the overall space required and connection dimensions,

refer to the installation diagrams;

• Refer to the installation diagrams at the beginning of this

handbook for the appliance's overall dimensions and

connections.

• The left side of the appliance must remain at least 500 mm

from other surfaces to enable maintenance operations

while the right side must be installed 100 mm from surfaces

made from flammable materials.

• Position the appliance on a flat surface.

• If necessary, adjust the height of the worktop by means of

the adjustable feet.

G.2

6-10 GN

Refer to the installation diagrams at the beginning of this

handbook.

• Fit a mechanical filter and shut-off tap between water inlet

pipe "C" and the mains water supply.

• Before connecting the filter, run off a certain amount of

water to remove any ferrous particles from the piping.

• The water inlet must be connected to a drinking water

supply with pressure of 150 – 250 kPa (1.5 – 2.5 bar / 22 –

36 psi).

G.2.1

• Connect drain fitting "C" to a drain pipe of the same

diameter which is between 0.5 and 3 metres in length and

is resistant to temperatures of at least 100℃.

20 GN