Table of Contents
Advertisement
If the appliance is to remain idle for long periods,
proceed as follows:
1. Disconnect from the electrical power supply at the isolat-
ing switch;
2. Close the water and gas taps (if the appliance is a gas
model);
3. Using a cloth soaked in Vaseline oil, vigorously rub the
stainless steel surfaces until they are well lubricated;
4. Periodically air the premises.
Changing the oven light bulb
If the oven light bulb burns out, proceed as follows:
1. Disconnect the appliance from the main power supply;
2. Unscrew the four screws fixing ring nut "A" to the light
fixture and remove glass shield "V" together with seal "G";
3. Remove halogen lamp "L" and replace with one with the
same characteristics (12V- 20W - 300℃);
Use a clean piece of paper/cloth to prevent direct contact
with your fingers.
L
4. Make sure the safety glass is correctly fitted inside the
seal and remount.
5. Lubricate the seal "G" with non-toxic silicon grease;
6. Then fix the ring nut using the four screws.
Replacing the oven door seal
NOTE!
The oven door seal is prone to normal wear and
should therefore be replaced as soon as it starts to
harden or crack.
To change the oven door seal, proceed as follows:
1. Prise the seal off its seat and remove any trace of old
silicon.
2. Apply silicon sealant to points "1" and "2" along the seal
support frame.
J
MACHINE DISPOSAL
J.1
Waste storage
At the end of the product's life-cycle, make sure it is not
dispersed in the environment.
Depending on the model, the doors must be removed before
scrapping the appliance.
V
G
A
3. Fit the new seal:
a. first push inside edge "1" over the corresponding seat
edge;
take care to press it round the corners.
b. stretch outside edge "2" of the seal over the other seat
edge using a hook.
General recommendations
• Do not wash the appliance with jets of water.
• Do not use products containing chlorine (bleach, hydro-
chloricacid etc.) even diluted, to clean the steel surfaces.
• Do not use corrosive substances (i.e. muriatic acid) to clean
the floor underneath the appliance.
MAINTENANCE, INSPECTIONS, CHECKS AND
CLEANING
Routine cleaning
General cleaning of machine and surround-
ing area
Mechanical protection devices
Check condition and for any deformation,
loosening or removed parts.
Control and Machine structure
Check mechanical part for any breakage or
deformation, tightening of screws. Check
readability and condition of words, stickers
and symbols and restore if necessary.
Electrical connection cable and plug
Check connection cable (replace it if neces-
sary ) and plug.
SPECIAL waste materials can be stored temporarily while
awaiting treatment for disposal and/or permanent storage. In
any case, the current environmental protection laws in the
user's country must be observed.
FRE-
QUENCY
Daily
Monthly
Yearly
Yearly
31
Advertisement
Table of Contents
