Gas Conversion Plate; Before Completing The Installation Operations; Servicing; G.10 Brief Troubleshooting Guide - Electrolux 6 GN 1/1 Installation And Operating Manual

Gas heated convection ovens

Hide thumbs

Table Of Contents

Table of Contents

3. Remove injector "B" and replace with the one correspond-

ing to the type of gas supply;

The injector identification number is stamped on the

injector body.

4. Reconnect the pilot line with fitting "A";

5. Remount ignition electrode "C".

The gas shut-off valve is not fitted with a minimum adjustment

screw. The operation of the burner is therefore ON or OFF.

WARNING

After conversion, refit the oven

outer panels.

G.10 Brief Troubleshooting guide

NOTE!

In case of malfunctioning:

1. Disconnect the appliance from the main power supply;

2. Switch off the safety circuit breaker ahead of the appliance;

3. Close the gas and water taps;

4. Contact the After-Sales Service with trained personnel and authorized by the manufacturer.

Certain faults may occur during normal use of the appliance

Malfunction

The pilot burner does not ignite.

The pilot burner goes out when the

ignition button is released.

The burner does not ignite when the

pilot burner is lit.

The oven temperature control does

not work

G.7.4

If the appliance is converted to a different gas supply, affix the

correct adhesive tag indicating the new gas type in a visible

location on the outside of the oven.

The relevant tag is selected from those contained in the bag

supplied with the appliance.

G.8

Switch on the appliance following the instructions for

use

• Use soapy water to check all gas connections for leaks;

DO NOT use a naked flame.

• Test the operation of the gas exhaust system;

• Remove the left side panel (where necessary) and check

the flame through the corresponding ports to check burner

ignition and flame uniformity.

• Explain the operation, routine maintenance and cleaning

instructions to the user.

G.9

Access to components requiring routine maintenance may be

easily gained by opening the control panel or removing the

LEFT side panel and rear panel.

Possible causes:

• Electrode poorly fixed or incorrectly connected;

• Electric ignition or electrode cable damaged;

• Insufficient gas pressure;

• Pilot injector clogged;

• Gas valve faulty.

• Thermocouple faulty or not sufficiently heated by pilot burner;

• Gas pressure low at valve;

• Gas valve faulty;

• Safety thermostat(s) tripped;

• Low pressure in gas pipes;

• Injector clogged;

• Gas valve faulty;

• Gas outlet holes on burner clogged;

• Motor thermal cut-out tripped;

• Timer faulty;

• Door micro-switch faulty or door not closed properly;

• Operating thermostat or bulb damaged.

• Operating thermostat faulty;

• Gas valve faulty.