Related Manuals for Rhima MED SPARKLE
Summary of Contents for Rhima MED SPARKLE
- Page 1 Operator’s Manual MED SPARKLE Washer Australia Tel: 1300 347 944 | New Zealand Tel: 0800 902 054 | Singapore Tel: +65 9107 8943...
-
Page 2: General Instructions
● Do not attempt to repair the appliance. Repairs made by unqualified persons may cause further damage and will void warranty. ● Repairs and servicing of this appliance must be carried out by Rhima personnel only. IMPORTANT CUSTOMER INFORMATION ● To request a service, detergents or rinse additive contact your local Rhima Service centre... -
Page 3: Electrical Installation
ELECTRICAL INSTALLATION This appliance is intended to be connected to a 15amp electrical supply and must be earthed. PLUMBING INSTALLATION The Australian installation shall be in accordance with The Plumbing Code of Australia (PCA). This appliance should be connected to a hot water supply (Max 65°C ) for in accordance with Australian Standard AS/NZS 3500.1. -
Page 4: Control Panel And Relative Symbols
CONTROL PANEL AND RELATIVE SYMBOLS Keys Switching – On / STAND BY key Regeneration key (not available) Drain key Extra cold rinse key (not avaiable) Info key START key to start up cycle / select cycle Display Display 55°C 70°C The display's indications, when machine ready, are listed below: 1) Tank status icon. - Page 5 Start the wash cycle • Insert the rack filled with objects to wash. The objects must be correctly placed in the rack. • If the desired cycle hasn't been selected before, it is possible to do it in this moment by keeping press the key Start The display will show in sequence all these available programs.
- Page 6 STOP pict. 2 Note: We recommend to change the tank water, by means of another filling, at least twice a day, or whenever needed. The machine is set to change all the wash-water automatically, every 30 cycles. Switching OFF • Keep pressed the key until it lights in red.
-
Page 7: Tank Draining
The detergent shall be the NO FOAM type, suitable for industrial dishwashers. The use of good quality liquid detergents is recommended such as those supplied by Rhima. Follow the manufacturer’s recommendations for chemical dosage, related to the local water hardness. - Page 8 WARNINGS: • Do not slam the door when opening and closing. • Do not put material or objects on the machine. • The machine has an IP (see serial number label on the machine) protection rating against accidental water splashes and is not protected against pressurized water jets.
-
Page 9: Daily Maintenance
DAILY MAINTENANCE WARNING: The machine is not protected against pressurized water jets. Do not use pressure cleaning system against the machine. It is recommended to contact the seller of chemicals for proper cleaning instructions, in order to have detailed indications on methods and products for the correct periodical machine sanitation. Do not use bleach or chlorine based detergents. -
Page 10: Signals And Alarms
Contact the Rhima Service Department Contact the Rhima Service Department Contact the Rhima Service Department This feature is not available ALARM SL8 - BREAK TANK HIGH LEVEL Contact the Rhima Service Department WATER LOSS Turn off machine. Contact the Rhima Service Department... -
Page 11: Troubleshooting
Streaks and spots on Too much rinse-aid chemical. Reduce the rinse aid amount. Contact the Rhima objects. Service Department. Too hard water. Check the water quality. Water must not exceed 8°f in hardness. - Page 12 Tel: 1300 347 944 New Zealand Tel: 0800 902 054 Singapore Tel: +65 9107 8943 DETERGENTS To request detergents or rinse additive contact your local Rhima Service centre below: Australia: 1300 347 944 New Zealand: 0800 902 054 Singapore: +65 9107 8943 Mediwash...
Need help?
Do you have a question about the MED SPARKLE and is the answer not in the manual?
Questions and answers