Related Manuals for Rhima RM 50
Summary of Contents for Rhima RM 50
- Page 1 Operator’s Manual RM 50 Washer Australia Tel: 1300 347 944 | New Zealand Tel: 0800 902 054 | Singapore Tel: +65 9107 8943...
-
Page 2: General Instructions
● Do not attempt to repair the appliance. Repairs made by unqualified persons may cause further damage and will void warranty. ● Repairs and servicing of this appliance must be carried out by Rhima personnel only. IMPORTANT CUSTOMER INFORMATION ● To request a service, detergents or rinse additive contact your local Rhima Service centre... -
Page 3: Electrical Installation
ELECTRICAL INSTALLATION This appliance is intended to be connected to a 15 Amp electrical supply and must be earthed. PLUMBING INSTALLATION The Australian installation shall be in accordance with The Plumbing Code of Australia (PCA). This appliance should be connected to a hot water supply (Max 65°C ) for in accordance with Australian Standard AS/NZS 3500.1. -
Page 4: Control Panel And Relative Symbols
CONTROL PANEL AND RELATIVE SYMBOLS Cycle light indicator Selected cycle indicator Tank temperatur display Boiler temperature display ON / OFF indicator Regeneration indicator (Not Available) Drain indicator START push-button to start up cycle / select cycle Cool extra indicator Switching – On / STAND BY button pict. -
Page 5: Switching Off
Operation • Insert the rack filled with dishes to wash. The plates must be correctly placed in the rack (see par. Cutlery and crockery loading). Close the door. • Select the wanted washing cycle (1, 2, 3, ∞) by pushing the button (see pict. - Page 6 Cutlery and crockery loading Before cutlery and crockery loading in the machine, coarsely clean them from the leftover food. It isn't necessary to rinse the cutlery an crockery under water. ATTENTION: Do not wash articles polluted with petrol, paint, chips of steel or iron, ash, sand, wax, lubricant grease.
-
Page 7: Detergent Use
Detergent use The detergent shall be the NO FOAM type, suitable for industrial dishwashers. The use of good quality liquid detergents is recommended. The detergent must be introduced in the tank. The amount is recommended by the manufacturers according to the water hardness. -
Page 8: Routine Maintenance
ECOLOGICAL ASPECTS Recommendations for optimal use of energy, water and additives Chemical dosing: A pre-set (by the manufacturer) quantity of Chemical is injected in the resins at each cycle. Use the machine fully loaded when possible: This shall prevent detergent, rinse aid, water and energy consumption waste. - Page 9 • Reassemble the parts and reposition the wash pipes firmly in place. Take extreme care to re-assemble the nozzles in the right position (open and / or closed nozzles) and that the arms are installed with the right axial angle. •...
-
Page 10: Signals And Alarms
Contact the Rhima Service Department. fl r Contact the Rhima Service Department. Feature not available. ALARM SL8 - BREAK TANK HIGH LEVEL * Contact the Rhima Service Department. ALARM SL8 - BREAK TANK FILLING Contact the Rhima Service Department. FAILURE **... -
Page 11: Troubleshooting
Streaks and spots on glasses Streaks and spots on glasses and Reduce the rinse aid amount. Contact the Rhima and dishes. dishes. Service Department. Too hard water. - Page 12 Tel: 1300 347 944 New Zealand Tel: 0800 902 054 Singapore Tel: +65 9107 8943 DETERGENTS To request detergents or rinse additive contact your local Rhima Service centre below: Australia: 1300 347 944 New Zealand: 0800 902 054 Singapore: +65 9107 8943 Mediwash...
Need help?
Do you have a question about the RM 50 and is the answer not in the manual?
Questions and answers