Removing The 2U Sled From The 1U Sled - Dell PowerEdge XR4520c Installation And Service Manual

Figure 21. Installing the 2U sled side cover
Next steps
Remove the 2U sled from the 1U

Removing the 2U sled from the 1U sled

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the side cover.
4. Remove the expansion card
5. Remove the riser 1C card.
6. Remove the cooling fan.
Steps
1. Disconnect the INT signal cable from the Power Interposer Board (PIB).
2. Using the Phillips 1 screwdriver, remove the screws that secure the 2U sled from the 1U sled.
3. Using both hands, lift the 2U sled from the 1U sled.
60 Installing and removing system components
sled.
Safety Instructions.
Before working inside your system
riser.