Table of Contents
Advertisement
Figure 23. Installing the 2U sled on the 1U sled
3. Pass the INT signal cable through the fix hook of the 2U sled and connect the power cable to the slot on the Power
Interposer Board (PIB).
Next steps
Install the expansion card riser
Cooling fans
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
sled.
Steps
1. Pull the blue latch on the side of the fan module.
2. Slightly pull back the fan handle to disengage it from the guiding pin and then lift to release the fan handle.
3. Disconnect the fan cable that is connected to the system board connector.
NOTE:
Fan 1, 2, and 3 are connected to the 1U sled system board.
4. Pull slightly to disengage the fan cable from the fan guard and then lift the fan module out of the fan cage.
NOTE:
If the airflow directional arrow is indicating outward on the fan, this indicates Reverse-Air-Flow (RAF). If the
airflow directional arrow is indicating inward on the fan, this indicates Normal-Air-Flow (NAF).
62
Installing and removing system components
1C.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
