Output Terminal Function Selection (Pr. 190 To Pr. 192) - Mitsubishi Electric FR-E540 K-EC Series Instruction Manual

Output terminal function selection (Pr. 190 to Pr. 192)

4.2.44 Output terminal function selection (Pr. 190 to Pr. 192)
Pr. 190 "RUN terminal function selection"
Pr. 191 "FU terminal function selection"
Pr. 192 "ABC terminal function selection"
You can change the functions of the open collector and contact output terminals.
Parameter Terminal
Number Symbol
190 RUN
191 FU
192 ABC
<Setting>
Refer to the following table and set the parameters:
Signal
Setting
Name
0 RUN Inverter running
1 SU Up to frequency
3 OL Overload alarm
Output frequency
4 FU
detection
Inverter operation
11 RY
ready
Output current
12 Y12
detection
Zero current
13 Y13
detection
14 FDN PID lower limit
15 FUP PID upper limit
PID forward-
16 RL reverse rotation
output
98 LF Minor fault output
99 ABC Alarm output
Note: 1. The same function may be set to more than one terminal.
2. Pr. 190 to Pr. 192 do not function if the values set are other than the above.
Factory
Setting
0
4
99
Function
Output during operation when
the inverter output frequency
rises to or above the starting
frequency.
Refer to Pr. 41 "up-to-frequency
sensitivity". (Note 1)
Output while stall prevention
function is activated.
Refer to Pr. 42, Pr. 43 (output
frequency detection).
Output when the inverter is
ready to be started by switching
the start signal on.
Refer to Pr. 150 and Pr. 151
(output current detection).
Refer to Pr. 152 and Pr. 153
(zero current detection).
Refer to Pr. 128 to Pr. 134 (PID
control).
Output when a minor fault
occurs.
Output when the inverter's
protective function is activated to
stop the output (major fault).
144
PARAMETERS
Factory-Set Terminal
Function
Inverter running
Output frequency detection
Alarm output
Operation
Setting
Range
0 to 99
0 to 99
0 to 99
Related
Parameters
Pr. 41
Pr. 22, Pr. 23,
Pr. 66
Pr. 42, Pr. 43
Pr. 150,
Pr. 151
Pr. 152,
Pr. 153
Pr. 128 to
Pr. 134
4
Pr. 244