Frequency Setting Mode; Parameter Setting Mode - Mitsubishi Electric FR-E540 K-EC Series Instruction Manual

3.2.4 Frequency setting mode

Set the frequency value used for operation performed under the operation command
given by the key (
RUN FWD
This mode is displayed only in PU operation.
Frequency setting mode
Hz
PU
MODE SET REV
STOP
FWD
RESET
MODE
To 3.2.5 Parameter setting mode

3.2.5 Parameter setting mode

With the exception of some parameters, parameter setting can be made only when the PU
operation mode is selected by the Pr. 79 setting.
A parameter value may either be set by updating its parameter number or setting
the value digit-by-digit using the
To write the setting, change it and press the
Note: If parameter write cannot be performed, refer to page 167.
or key) in the PU operation mode.
REV
Set frequency changing
Change the set
frequency with
/ key.
51
OPERATION
To frequency monitoring
Set frequency write
SET
Hz
PU
Flicker
key for about 1.5 seconds.
SET
MODE
Hz
PU
Hz
PU
3