Console Port - NETGEAR ProSafe FSM7352PS Installation Manual

48+4 fast ethernet l3 managed stackable switch with poe
Hide thumbs Also See for ProSafe FSM7352PS:
Table of Contents

Advertisement

4-10/100/1000M Ports
Three LED / Port

Console Port

Your NETGEAR Model FSM7352PS ProSafe 48+4 Fast Ethernet L3 Managed Stackable Switch with PoE
has a console port on the front panel. This port is labeled Console and is required for initial
management configuration of the switch. It also lets you manage the switch using a directly connected
VT-100 terminal, personal computer (PC), Apple Macintosh, or UNIX workstation. The terminal, computer,
or workstation connects to the console port using the null-modem cable supplied with your switch.
The console port is configured to use the following settings:
Baud rate: 9,600 bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
These settings appear below the connector on the switch front panel.
In addition to using the console port, you can manage the switch using a Web browser or a Simple Network
Management Protocol (SNMP) management program.
For more information about console-port connections, see "Connecting to the Console Port" in Chapter 3
Installation. For more information about managing the switch, see the User Manual located on the CD-
ROM.
Copper Link/ACT LED :
OFF –No 10/100/1000Mbps link is established on the port.
Solid Green – A valid 1000Mbps link is established on the port.
Solid Yellow – A valid 10/100Mbps link is established on the port.
Blinking Green – Packets transmission or reception is occurring on the
port at 1000Mbps.
Blinking Yellow – Packets transmission or reception is occurring on the
port at 10/100Mbps.
SFP Link/ACT LED :
OFF –No 1000Mbps link is established on the port.
Solid Green – A valid 1000Mbps link is established on the port.
Blinking Green – Packets transmission or reception is occurring on the
port at 1000Mbps.
Stack LED:
In Stack mode
Green –When stack partner successfully established the link.
Blinking Green –when switch detects the link active but stack partner
failed to establish the link
OFF –No link
In Non-stack mode
OFF –Regardless the link is present or not
Page 12 of 24

Advertisement

Table of Contents
loading

Table of Contents