Step 5: Connecting Devices To The Switch; Step 6: Installing A Sfp Module; Figure 3-2. Connecting Devices To The Switch - NETGEAR ProSafe FSM7352PS Installation Manual

48+4 fast ethernet l3 managed stackable switch with poe

Hide thumbs Also See for ProSafe FSM7352PS:

Table of Contents

not have an ON/OFF switch; the only method of applying or removing AC power is by connecting or

disconnecting the power cord. Before you connect the power cord, select an AC outlet that is not controlled

by a wall switch, which can turn off power to the switch. After you select an appropriate outlet, use the

following procedure to apply AC power.

1. Connect the female end of the supplied AC power adapter cable to the power receptacle on the back of

the switch.

2. Connect the 3-pronged end of the AC power adapter cable to a grounded 3-pronged AC outlet.

When you apply power, the Power LED on the switch's front panel will be Yellow, as it conducts a Power

On Self Test (POST). After the switch passes the POST, the Power LED will change to Green and the

switch is functional and ready to pass data. If the POST failed, the Power LED will blink in yellow.

If the Power LED does not go on, check that the power cable is plugged in correctly and that the power

source is good. If this does not resolve the problem, refer to Appendix B, Troubleshooting.

Step 5: Connecting Devices to the Switch

The following procedure describes how to connect devices to the switch's network RJ-45 ports. Your

NETGEAR Model FSM7352PS ProSafe 48+4 Fast Ethernet L3 Managed Stackable Switch with PoE

contains Auto Uplink™ technology, which allows you to attach devices using either straight-through or

crossover cables.

Connect each device to an RJ-45 network port on the switch's front panel (see Figure 3-2). Use Category 5

(Cat5) unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make these connections.

Note: Ethernet specifications limit the cable length between the switch and the attached device to 100 m

(328 ft).

The following procedure describes how to install a SFP Gigabit Ethernet module in the switch's Gigabit

module bays. The Standard SFP Module is sold separately from the FSM7352PS. If you do not want to

install a SFP module at this time, skip this procedure.

To install a SFP module:

1. Insert the SFP module into the SFP module bay. Press firmly to ensure the module seats into the

connector.

Page 15 of 24

Table of Contents