Example #4. Enable Rip For Ports 1/2/2 And 1/2/3; Ospf - NETGEAR ProSafe FSM7328S Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide

Example #4. Enable RIP for ports 1/2/2 and 1/2/3

This command sequence enables RIP for ports 1/2/2 and 1/2/3. Authentication defaults to none,
and no default route entry is created. The commands specify that both ports receive both RIPv1
and RIPv2 frames, but send only RIPv2 formatted frames.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/2/2
(Netgear Switch) (Interface 1/2/2)#ip rip
(Netgear Switch) (Interface 1/2/2)#ip rip receive version both
(Netgear Switch) (Interface 1/2/2)#ip rip send version rip2
(Netgear Switch) (Interface 1/2/2)#exit
(Netgear Switch) (Config)#interface 1/2/3
(Netgear Switch) (Interface 1/2/3)#ip rip
(Netgear Switch) (Interface 1/2/3)#ip rip receive version both
(Netgear Switch) (Interface 1/2/3)#ip rip send version rip2
(Netgear Switch) (Interface 1/2/3)#exit
(Netgear Switch) (Config)#exit

OSPF

For larger networks Open Shortest Path First (OSPF) is generally used in preference to RIP. OSPF
offers several benefits to the administrator of a large and/or complex network:
• Less network traffic:
– Routing table updates are sent only when a change has occurred
– Only the part of the table which has changed is sent
– Updates are sent to a multicast, not a broadcast, address
• Hierarchical management, allowing the network to be subdivided
The top level of the hierarchy of an OSPF network is known as an autonomous system (AS) or
routing domain, and is a collection of networks with a common administration and routing
strategy. The AS is divided into areas: intra-area routing is used when a source and destination
address are in the same area, and inter-area routing across an OSPF backbone is used when they
are not. An inter-area router communicates with border routers in each of the areas to which it
provides connectivity.
The 7000 Series Managed Switch operating as a router and running OSPF will determine the best
route using the assigned cost and the type of the OSPF route. The order for choosing a route if
more than one type of route exists is as follows:
5-18
v1.0, March 2006
IP Routing Services