NETGEAR 7000 Series Managed Switch Administration Guide
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/3/1
(Netgear Switch) (Interface 1/3/1)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/3/1)#exit
(Netgear Switch) (Config)#interface 1/3/2
(Netgear Switch) (Interface 1/3/2)#ip address 192.150.4.1 255.255.255.0
(Netgear Switch) (Interface 1/3/2)#exit
Specify the router ID and enable OSPF for the switch.
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config router)#router-id 192.150.9.9
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
Enable OSPF for the VLAN and physical router ports.
(Netgear Switch) (Config)#interface 1/3/1
(Netgear Switch) (Interface 1/3/1)#ip ospf areaid 0.0.0.2
(Netgear Switch) (Interface 1/3/1)#ip ospf
(Netgear Switch) (Interface 1/3/1)#exit
(Netgear Switch) (Config)#interface 1/3/2
(Netgear Switch) (Interface 1/3/2)# ip ospf areaid 0.0.0.3
(Netgear Switch) (Interface 1/3/2)#ip ospf
(Netgear Switch) (Interface 1/3/2)#exit
Set the OSPF priority and cost for the VLAN and physical router ports.
(Netgear Switch) (Config)#interface1/3/1
(Netgear Switch) (Interface 1/3/1)#ip ospf priority 128
(Netgear Switch) (Interface 1/3/1)#ip ospf cost 32
(Netgear Switch) (Interface 1/3/1)#exit
(Netgear Switch) (Config)#interface 1/3/2
(Netgear Switch) (Interface 1/3/2)#ip ospf priority 255
(Netgear Switch) (Interface 1/3/2)#ip ospf cost 64
(Netgear Switch) (Interface 1/3/2)#exit
(Netgear Switch) (Config)#exit
Routing Information Protocol
Routing Information Protocol (RIP) is one of the protocols which may be used by routers to
exchange network topology information. It is characterized as an "interior" gateway protocol, and
is typically used in small to medium-sized networks.
5-14
v1.0, March 2006
IP Routing Services