Enable Rip For Ports 1/0/2 And 1/0/3 - NETGEAR GSM7252PS - ProSafe 52 Ports Gigabit Ethernet L2 Managed Stackable Switch Software Administration Manual

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
CLI: Enabling RIP for the Switch
The next sequence enables RIP for the switch. the route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enabling RIP on the Switch
To use the Web interface to configure the managed switch, proceed as follows:
1. From the main menu, select Routing > RIP > Basic>RIP Configuration. A screen similar to the
following displays.
Figure 5-5
2. Next to the RIP Admin Mode, select Enable Radio button.
3. Click Apply to save the setting.

Enable RIP for Ports 1/0/2 and 1/0/3

The example is shown as CLI commands and as a Web interface procedure.
CLI: Enabling RIP for Ports 1/0/2 and 1/0/3
This command sequence enables RIP for ports 1/0/2 and 1/0/3. Authentication defaults to none, and no
default route entry is created. The commands specify that both ports receive both RIPv1 and RIPv2 frames,
Routing Information Protocol
v1.0, June 2010
5-6