Installation Notes - Flush-Fit - Miele KM 7678-2 FL Operating And Installation Instructions

Installation notes –
flush-fit
A flush-fit cooktop is suitable only for
installation in natural stone (granite,
marble), solid wood and tiled
worktops. When using a worktop
made from any other material, please
check first with the worktop
manufacturer that it is suitable for
installing a flush-fit cooktop.
The internal width of the base unit
underneath the appliance must be at
least as wide as the inner worktop cut-
out (see "Installation – Installation
dimensions – Flush-fit"), so that the
cooktop is easily accessible from
underneath after installation and the
bottom half of the casing can be
removed for maintenance. If the
underside of the cooktop is not freely
accessible after installation, any
sealant used to plug the gaps around
the appliance must be removed to
enable the cooktop to be lifted out of
the cut-out should this be necessary.
Natural stone worktops
The cooktop is placed directly in the
cut-out.
Solid wood worktops, tiled worktops,
glass worktops
The cooktop is placed on a wooden
frame inside the cut-out. The frame
must be provided on site and is not
supplied with the appliance.
Sealing strip
Dismantling the cooktop for service
purposes may damage the sealing
strip underneath the edge of the
cooktop.
Always replace the sealing strip
before reinstalling the cooktop.
Do not install DiamondFinish
cooktops in front of a window
It is not recommended to install
DiamondFinish models in front of a
window.
Direct daylight causes the surface of
the cooktop to reflect more strongly and
makes the indicators more difficult to
recognise.
Installation
67