Switching On The Cooktop; Setting The Power Level; Switching The Cooktop Off; Residual Heat Indicator - Miele KM 7678-2 FL Operating And Installation Instructions


Risk of fire due to overheated
food.
Unattended food can overheat and
ignite.
Do not leave the cooktop unattended
whilst it is being used.
Please note that the heating-up time
on induction cooktops is much
shorter than on conventional
cooktops.

Switching on the cooktop

 Touch the  sensor.
Further sensor controls will light up.
If no further entry is made, the
cooktop will switch itself off after a
few seconds for safety reasons.

Setting the power level

 Place the pans in the required
position on the cooktop.
The corresponding numerical keybank
lights up.
 Touch the appropriate sensor control
on the numerical keybank for the
power level you want.
If you do not set a power level within
approx. 10 seconds, the numerical
keybank will go out.

Switching the cooktop off

 Touch the  sensor.

Residual heat indicator

If an area of the ceramic surface is hot,
the residual heat indicator will light up
after the cooktop has been switched
off. Depending on the temperature, a
dot will appear above power levels 1, 2
and 3.
The dots of the residual heat indicator
go out one after the other as the
ceramic surface cools down. The last
dot only goes out when the ceramic
surface is safe to touch.

Risk of burning due to hot
ceramic surface.
The ceramic surface will be hot after
use.
Do not touch the ceramic surface
while the residual heat indicators are
on.
Setting the power level –
extended power level range
 Touch the numerical keybank
between two number sensors.
The sensors in front of and after the
interim level will light up brighter than
the other sensors.
Example:
If you have set power level 7., the
numbers 7 and 8 will be brighter than
the other numbers.
Operation
33