Rebooting The Device - H3C WAC360 Series Installation Manual

Rebooting the device

CAUTION:
If the main system software image file is corrupted or does not exist, the device cannot reboot. You
•
must re-specify a main system software image file, or power off the device and power it again on so
the system can reboot with the backup system software image file.
• Save your configuration before device reboot to avoid data loss. The device displays "REBOOT IN
ONE MINUTE" appears one minute before it is rebooted.
For security purposes, if you are performing file operations at the reboot time, the system does not
•
reboot.
When upgrading and maintaining the system software image file or the configuration file for the device,
you must reboot the device. To reboot a device, use one of the following methods:
• Reboot the device immediately at the CLI.
Schedule a reboot at the CLI to occur at a specific time and date or after a delay.
•
Power off and then power on the device again. Because this method can cause data loss, H3C
•
recommends that you use one of the CLI methods.
To reboot the device immediately:
Task
Reboot the device immediately.
To schedule a reboot for the device:
Task
Schedule a reboot.
Command
Reboot
Command
•
Schedule a reboot to occur at a specific
time and date:
schedule reboot at hh:mm [ date ]
•
Schedule a reboot to occur after a delay:
schedule reboot delay { hh:mm | mm }
21
Remarks
Required.
Available in user view.
Remarks
Use either command.
The scheduled reboot function is
disabled by default.
Available in user view.