Introduction - AKCP SP1+ User Manual

Introduction

In this manual, we'll cover the main features and basic configuration of the SP1+ and the setup of
notifications and the explanation of events will be in the SP1+ "Notifications" manual here as the units
web interface & notifications are the same (just keep in mind this unit only has one sensor port):
http://www.akcp.in.th/downloads/Manuals/SP1+/SP1+%20Notifications%20Manual.pdf
Please also see our Knowledge Base page here:
base/sensorprobe-plus-series-knowledge-base/
What is the SP1+?
The SP1+ is a high speed, accurate, compact, intelligent monitoring device, featuring a completely
embedded host and operating system. The SP1+ is a complete redesign of the world's best-selling
environmental monitoring platform, 3 years in the making with all new hardware and software.
We've combined the low cost and simplicity of use of the SP1 & SP1+, along with many advanced
features of our securityProbe platform.
The SP+ units support a maximum of 150 sensors (data points) per unit. This unit supports up to 1
(physical) sensor.
SP1 + Features:
● IP based, including SNMPv3, HTTPS, VPN
● Send encrypted SNMP Trap and Email Notifications
● Supports 1 Intelligent Sensors and 1 Dry Contact
● Notification Wizards
● Front and Rear Thermal Mapping for any server cabinet
● Virtual Sensors
● AKCP Swing Handle Lock support
Please check all the specifications & features on our SP1+ datasheet:
https://www.akcp.com/akcp-products/sp1-plus/
Important notes:
A) Some of the pictures shown in this manual might not represent the actual Web UI of the SP1+ unit;
this is because we are constantly working on improving the firmware. Some may represent the SP1+,
but will still apply to the SP1+ units.
B) All SP+ H7 type units with firmware version 1.0.5824 or higher are now shipped with DHCP
enabled by default. See below for more details. If you do not use DHCP on your network, the unit
https://www.akcp.com/knowledge-
- 4 -