Information Menu In Connection With Drc-Dr; Activating The Information Menu; Selecting The Information Source; Activating The Crab Selection Screen - DEMAG DRC-MJ D3 User Manual

9

Information menu in connection with DRC-DR

9.1 Activating the
information menu
9.2 Selecting the
information source
9.3 Activating the crab
selection screen

9.4 Start screen

9.5 Navigating in the
information menu
50
This additional function of the DRC-MJ D3 hand-held transmitter can only be used
in connection with a DR/DMR rope hoist equipped with processor control and a
matching DRC-DR D3 radio receiver (part no. 711 333 45).
The Information menu makes it possible to display information about the crane or
the travelling hoist(s). This information is stored in the form of a list by each DR/
DMR control system. One element of this list is requested by the DRC-MJ D3
hand-held transmitter and made available by the selected control system via the
CAN bus.
– Hold the STOP button down.
– Press stage 1 of the HORN button twice.
– Hold stage 1 of the HORN button down for approx. 5 seconds.
– Release the HORN button.
– Release the STOP button.
The polled control system can be selected in the same way as for the travelling
hoist. Since the F1 key has no function in the information menu, the crab must first
be selected in Run mode:
Crab selection Information from
I Crab 1 control system
II Crab 2 control system
I+II Crane control system
If only one crab is available on the crane, no crab needs to be selected; therefore,
no crab selection is shown on the control unit screen. However, if crab selection
still needs to be activated, this can be achieved by holding the F1 key down on the
DRC-MJ D3 hand-held transmitter for 5 seconds.
After changing to the Information menu, the start screen of the Information menu
is shown on the display of the DRC-MJ D3 hand-held transmitter. This start screen
shows START II (since crab 2 has been selected) and code 888:
Information code
Information
(Crab II start information)
Use the following buttons to navigate in the information list:
Button Function
RIGHT Continue to the next value in the list
LEFT Return to the previous value in the list
LIFT Exit the Information menu
K564
888:
START
42660744.eps