Taking The Equipment Out Of Service At The End Of The Shift (Standby Or Switching Off) - DEMAG DRC-MJ D3 User Manual

8.5 Taking the equipment
out of service at the
end of the shift (stand-
by or switching off)
1
43678844.eps
8.5.1 Storing hand-held
transmitters that are not in
use
At the end of a shift and during longer breaks, DRC-MJ D3 hand-held transmitters
must be switched to Standby mode or switched off completely by the key
sequence as shown to protect the installation against unauthorised use and to
reduce power consumption of the DRC-MJ D3 hand-held transmitter. The time
after the end of the shift or longer breaks should be used to re-charge the batteries
by connecting them to the charger unit.
2
3
Press 3 x
(standby)
or
Press 6 x
(switch off)
Red
Press
1 x
Hold down
1. Hold the STOP button down while taking the equipment out of service.
2. Transmitter is in STOP mode
3a. Standby: push the LOWER joystick 3 times.
or
3b. Switch off: push the LOWER joystick 6 times.
4. Release all buttons.
Hand-held transmitter locked, Standby mode
If a DRC-MJ D3 hand-held transmitter is not used for some time (several weeks),
the batteries should first be fully charged and then removed from the DRC-MJ D3
hand-held transmitter (see section 8.6.5). The batteries can be stored for several
months when they are charged. If required, the charging process should be
repeated after some time.
DRC-MJ D3 hand-held transmitter locked, Standby
mode.
43679844.eps
4
43679944.eps
47