Crane Operation/Run - DEMAG DRC-MJ D3 User Manual

8.4 Crane operation/Run

8.4.1 On key
2
Red
Press
1 x
1
43678844.eps
8.4.2 Functions in crane operation
Run mode of the radio control system must be started for crane operation. To do
this, the electronic On key must be entered.
The On key is used to
• switch from Standby (lock icon) to Run mode,
• switch from STOP to Run/crane operation mode.
3
Press
3 x
Hold down
1. Hold the STOP button down during the log-on process.
2. Transmitter is in STOP mode
3. Push the LIFT joystick 3 times.
4. Release all buttons.
The radio transmitter is in RUN mode.
The LED in the display fi eld fl ashes green if Run mode is switched on after
entry.
DRC-MJ D3 hand-held transmitters use so-called mini-joystick control elements to
control the three motion axes.
Thanks to these control elements, a DRC-MJ hand-held transmitter has the
same the scope of functions as those of classic hand-held transmitters that have
10 buttons (such as a DRC-10 D3), despite the fact that it has considerably smaller
dimensions.
The upper mini-joystick control element is only designed for vertical control
movements and can be used for the proportional control of one motion axis
(typically lifting and lowering).
The lower mini-joystick control element enables two motion axes to be controlled
usually for the control of long-travel and cross-travel axes for hoist and crane
applications.
Both mini-joystick control elements have a mechanical detent, which enable an
operator to feel clearly when a slow speed has been reached.
The lower mini-joystick control element also enables diagonal travel motions
to be performed. This diagonal travel motion function can also be de-activated.
See hand-held transmitter parameter programming: section P1, parameter 508
(electronic gate).
43679744.eps
4
Green
43679144.eps
43