P1.2 Further Information On The Parameters - DEMAG DRC-MJ D3 User Manual

Use the RIGHT and LEFT joystick to select the parameter to be displayed. The
LIFT joystick can be used to exit the menu at any time.
The F1 key can be used to change to entry and selection mode for certain
parameters that can be edited (Edit column = Yes). An Equals symbol (=) is shown
after the parameter number in entry and selection mode.
Use the RIGHT and LEFT joystick to select a new parameter value.
Use the F2 key to accept a newly selected parameter.
Use the LIFT joystick to exit the parameter programming menu.
P1.2 Further information 501 Serial no.
on the parameters Cannot be changed (read only)
Describes the hand-held transmitter serial number
502 SW version
Cannot be changed (read only)
Describes the software version of the hand-held transmitter
503 HW version
Cannot be changed (read only)
Describes the hardware version of the hand-held transmitter
504
Parameter not assigned
505 Stop -> Standby timeout
Parameter can be changed
This parameter defines the time after which the unit switches from Stop mode into
power-saving Standby mode.
Adjustment in seconds
Default: 300 (300 seconds = 5 minutes)
Adjustable values between 00010 (min.) and 65535 (max.)
506 RUN –> Standby timeout
Parameter can be changed
This parameter defines the time after which the unit switches from RUN mode into
power-saving Standby mode.
Adjustment in seconds
Default: 1800 (1800 seconds = 30 minutes)
Adjustable values between 00000 (min.) and 65535 (max.)
Note: Value of 00000 means the function is deactivated
507
See section P1.3
508
See section P1.4
60