P2 Fcc And Industry Canadian Information; P2.1 Fcc Information; P2.2 Industry Canadian Information - DEMAG DRC-MJ D3 User Manual

P2 FCC and Industry Canada information

P2.1 FCC information

P2.2 Industry Canada
information
64
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
Francais
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (A)/NMB-3(A)
The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
When the device is stored on the operators belt it must be shut off. Pressing the
buttons and operating the machine while the device is hanging from the belt or any
other place is not allowed. It must be held in the hand.
The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit RF field in excess of Health Canada limits for the
general population; consult Safety Code 6, obtainable from Heath Canada's web-
site www.hc-sc.gc.ca/rpb.
Francais
L'antenne (s) utiliseé pour cet émetteur doit être installé pour fournir une distance
de séparation d'au moins 20 cm de toute personne et ne doit pas être
co-localisées ou opérant en conjonction avec une autre antenne ou émetteur.
Lorsque l'appareil est stocké sur la bande des opérateurs, il doit être arrêté. Ap-
puyant sur les boutons et faire fonctionner la machine alors que l'appareil est
accroché à la ceinture ou tout autre lieu il pas permis. Il doit être tenu à la main.
L'installateur de cet équipement radio doit veiller à ce que l'antenne est située
ou orientée de façon qu'il ne dégage pas de champ RF dépassant les limites de
Santé Canada pour la population générale; Consultez le Code de sécurité 6, dis-
ponible sur le site web de www.hc-sc.gc.ca/rpb de Santé Canada.
CAUTION.
Loss of user's authority to operate the equipment!