Connecting To Remote - Miller XMT 350 FieldPro Owner's Manual

5-10. Connecting To Remote

3
6
7
OM-282217 Page 24
RHC-14 Or Wireless Remote Connection
2
4
FieldPro Remote Connection
1
1
4
2
3
This power source can be used with
either the FieldPro
RHC−14 remote, or
remote (see RHC−14 remote or
wireless remote Owner's Manual
for operating instructions).
1 Power Source
2 TIG Torch (Shielding Gas Not
Shown)
3 Electrode Holder
When using an RHC-14 or wireless
remote, connect TIG torch or
electrode holder directly to the
ELECTRODE (top)
receptacle.
4 Work Cable
Connect work cable to WORK
(bottom) output receptacle on the
front of the welding power source.
Attach work cable clamp as close to
the arc as possible.
5 Work Sense Lead
When using a FieldPro Remote,
attach work sense lead clamp next
to the work cable clamp. Connect
the other end of the work sense
lead to the binding post on the side
of the FieldPro Remote.
6 RHC−14 Remote Or Wireless
Remote
Connect RHC-14 or wireless
remote to 14-pin receptacle on the
front of the power source.
7 FieldPro Remote
Connect one end of the weld cable
to ELECTRODE (top) output
receptacle on the front of the power
source and the other end to the
FieldPro Remote. Connect the TIG
torch or electrode holder to the
other side of the FieldPro Remote.
.
The RHC-14 or wireless re-
mote can be used with the
FieldPro Remote to allow am-
perage adjustment
welding.
5
Remote,
wireless
output
during
279998-B